8-29-17

Today Ilan, Chris, Will and I tried to fly the drones. It didn't work out very well because all the Inspire batteries were dead. Also, we need to do some firmware updates on the Inspires. Our next try was with the Mavic, but the remote battery was dead, so Ilan and I flew it a little with his phone over the wifi capabilities, and we flew it inside a little just for fun. We also looked at the laser printer that was out of the box and on the table. We threw around some ideas with everyone about moving the table, and Dr. Bill talked to us about how we need bigger fans. Lastly, Will and I worked on the drone some. I removed a screw and pillar not needed on the power distribution board, and then marked the spot on the drone frame where we need to drill to make room for another attach point for the distribution board. Here are some pictures.