Tags

    8-28-17

    Comments

    Today, we talked a bunch at the beginning of the class. Dr. Bill checked in with everyone and we all talked about how our projects were going and what we were going to work on this week. After that Will, Chris, and I went outside to help Dr. Bill and Sameer clean up the tomatoes left over from last year. We cleaned out the remaining piping that had plants in them, emptied out the bucket of water it was sitting in, and swept the patio and hosed it off. That took up most of the class, but it was ok cause we got to eat some good tomatoes. After that, I went inside, took the power distribution board off the drone, and looked at a place where we could drill a hole to create another attach point for the distribution board because now we only have two holes that line up with the drone frame. After I removed the distribution board, class ended, so I didn't get any further. Next class, I want to mark and drill that new hole, attache the distribution board, and begin attaching the flight controller.